Yamaha trim tilt problem

Yamaha strokes trim tilt issue. Unsubscribe from shannon Vo? It could just be low on fluid.

Dedicated to my father who taught me early on that if I set my mind to a task, I could accomplish whatever I. I got to my fishing hole, fished a little.

When I decided to leave I tried to trim it down and it would just make a clicking noise. I tired to raise it up and then down and it wont go down. Currently, it is stuck in the up most position.

Engine and boat efficiency are improved by proper trim. Troubleshooting, Testing and Bypassing SPDT Power Trim Tilt Relays Does the electric trim and tilt pump motor not move at all? Hi All- New to the forum and like most newbies-need your help!

It works intermittently.

When is is not working I get a clicking sound with either switch at the motor or the throttle controls, up or down. I can tap the side of the housing and it will work perfectly for a while. Do I need to replace trim motor? Without any visible reason, the stroke is.

It means that when I put it into reverse I have to be very careful about the throttle otherwise the motor easily comes out of the water. Prior to that problem – Answered by a verified Marine Mechanic. Power Tilt and Trim Maintenance Makes a Difference.

Was out with friends fishing a tournament over the weeekend and motor got stuck in up position. Tried to release pressure screw but its frozen. Got towed back to ramp for 2. Got it home and looked at it the next day.

Trim started working again but very slow . I have a small problem with my trim tilt switch on the remote control thats on the helm. The trim tilt switch on the motor works fine so im pretty sure its the throttle control trim tilt. Some times it works just fine and other time I have to mess with the switch ( press up and down up and down ext ) to get it to work.

I had a switch go bad and the Switch turned on the motor to run in the UP mode. I discovered this after bouncing across I-2around Richmond a week ago. Motor tilts up but will not go down.

loading...